Flange Pressure Rating Class 150 to 2500 PN Selection Guide

Understanding Flange Pressure Ratings

Flange pressure rating indicates the maximum pressure a flange can safely withstand at a specific temperature. Selecting the correct rating is critical for system safety and compliance.

ASME Pressure Classes

ชั้นเรียน	Max Pressure (bar)	Max Pressure (psi)	Typical Applications
Class 150	19.6	285	Low pressure water, air, general service
Class 300	51.7	750	Medium pressure steam, process piping
Class 600	110.4	1600	High pressure steam, oil and gas
Class 900	165.5	2400	High pressure process lines
Class 1500	275.9	4000	Very high pressure, wellhead equipment
Class 2500	459.8	6670	Extreme pressure applications

European PN Ratings

PN Rating	Pressure (bar)	Equivalent ASME Class
PN6	6	Below Class 150
PN10	10	Below Class 150
PN16	16	Class 150
PN25	25	Class 150
PN40	40	Class 300
PN63	63	Class 400
PN100	100	Class 600

ข้อควรพิจารณาเกี่ยวกับอุณหภูมิ

Pressure ratings decrease as temperature increases. A Class 150 flange rated at 285 psi at ambient temperature may only be rated at 150 psi at 400°F (204°C).

Material Impact on Rating

• เหล็กกล้าคาร์บอน (A105): Standard pressure-temperature ratings
• Stainless Steel (304/316): Similar ratings, better corrosion resistance
• Alloy Steel (F11/F22): Maintains strength at higher temperatures
• Duplex Steel: Higher strength allows thinner designs

Rating Selection Factors

1. Design Pressure: Maximum expected system pressure
2. Design Temperature: อุณหภูมิการทำงานสูงสุด
3. Safety Margin: Add 10-25% above normal operating pressure
4. Pressure Surges: Consider water hammer and transient conditions
5. Code Requirements: ASME B31.1, B31.3, or local regulations
6. Future Expansion: Allow for potential capacity increases

ข้อผิดพลาดทั่วไปที่ควรหลีกเลี่ยง

• Using ambient temperature rating for elevated temperature service
• Ignoring pressure surges and transient conditions
• Mixing different pressure class flanges without proper reducers
• Not considering corrosion allowance for long-term service
• Overlooking vacuum conditions (external pressure)

Standards and Codes

• ASME B16.5: Pipe flanges and flanged fittings (NPS 1/2 to 24)
• ASME B16.47: Large diameter flanges (NPS 26 to 60)
• EN 1092-1: European steel flanges
• ASME B31.1: Power piping code
• ASME B31.3: Process piping code

Pressure Testing Requirements

Flanges are typically hydrostatically tested at 1.5 times their rated pressure to verify integrity before being put into service.

Proper flange pressure rating selection ensures safe, reliable, and code-compliant piping system operation throughout its design life.

WhatsApp: +86-18658777855
อีเมล: 1007788887@qq.com