Guida completa alle procedure di serraggio dei bulloni a flangia

Introduction

Proper bolt torquing is critical for achieving a leak-free flange joint. Incorrect torque can lead to gasket damage, flange warping, or insufficient sealing pressure. This guide covers best practices for flange bolt torquing.

Why Proper Torque Matters

Under-torquing causes:

• Insufficient gasket compression
• Leak paths through the gasket
• Vibration-induced loosening

Over-torquing causes:

• Gasket crushing and extrusion
• Flange face damage
• Bolt stretching or failure
• Uneven load distribution

Torque Calculation

Basic Formula

T = K × D × P

• T = Torque (Nm or ft-lbs)
• K = Nut factor (typically 0.2 for lubricated bolts)
• D = Bolt nominal diameter (mm or inches)
• P = Desired bolt preload (N or lbs)

Industry Standard Torque Values

For ASME B16.5 flanges with spiral wound gaskets:

• Class 150: 50-70% of bolt yield strength
• Class 300-600: 60-75% of bolt yield strength
• Class 900-2500: 70-80% of bolt yield strength

Step-by-Step Torquing Procedure

Step 1: Preparation

• Clean flange faces and inspect for damage
• Verify gasket type and condition
• Lubricate bolt threads and nut faces
• Check bolt length (should protrude 2-3 threads)

Step 2: Hand Tightening

• Insert all bolts finger-tight
• Ensure gasket is properly centered
• Verify flange alignment

Step 3: Initial Torque (30%)

• Use crisscross pattern (star pattern)
• Apply 30% of final torque to all bolts
• Number bolts sequentially for tracking

Step 4: Intermediate Torque (60%)

• Follow same crisscross pattern
• Increase to 60% of final torque
• Check flange gap for evenness

Step 5: Final Torque (100%)

• Apply 100% torque in crisscross pattern
• Go around twice to ensure uniformity
• Record all torque values

Torque Pattern Examples

4-Bolt Flange

Pattern: 1 → 3 → 2 → 4 (opposite bolts)

8-Bolt Flange

Pattern: 1 → 5 → 3 → 7 → 2 → 6 → 4 → 8

12-Bolt Flange

Pattern: 1 → 7 → 4 → 10 → 2 → 8 → 5 → 11 → 3 → 9 → 6 → 12

Tools and Equipment

• Calibrated torque wrench: Essential for accuracy
• Hydraulic torque wrench: For large diameter flanges
• Torque multiplier: For high-torque applications
• Bolt tensioner: For critical high-pressure joints

Common Mistakes to Avoid

• ✗ Using impact wrenches (causes uneven torque)
• ✗ Skipping the crisscross pattern
• ✗ Not lubricating threads
• ✗ Reusing damaged or stretched bolts
• ✗ Ignoring torque wrench calibration (should be calibrated annually)
• ✗ Torquing in circular sequence instead of crisscross

Post-Installation Checks

• Visual inspection for even gasket compression
• Check flange parallelism (gap should be uniform)
• Document all torque values for maintenance records
• Schedule re-torque after 24 hours if required

Conclusion

Proper bolt torquing is both an art and a science. Following standardized procedures ensures safe, leak-free operation and extends the service life of your flange joints. Always train personnel on proper techniques and maintain calibrated tools.

WhatsApp: +86-18658777855

E-mail: 1007788887@qq.com

✓ MTR with NDT reports ✓ Third-party inspection welcome