Flange Pressure Rating Class 150 to 2500 PN Selection Guide

Understanding Flange Pressure Ratings

Flange pressure rating indicates the maximum pressure a flange can safely withstand at a specific temperature. Selecting the correct rating is critical for system safety and compliance.

ASME Pressure Classes

班级	Max Pressure (bar)	Max Pressure (psi)	Typical Applications
150 级	19.6	285	Low pressure water, air, general service
300 级	51.7	750	Medium pressure steam, process piping
600 级	110.4	1600	High pressure steam, oil and gas
Class 900	165.5	2400	High pressure process lines
Class 1500	275.9	4000	Very high pressure, wellhead equipment
Class 2500	459.8	6670	Extreme pressure applications

European PN Ratings

PN Rating	Pressure (bar)	Equivalent ASME Class
PN6	6	Below Class 150
PN10	10	Below Class 150
PN16	16	150 级
PN25	25	150 级
PN40	40	300 级
PN63	63	Class 400
PN100	100	600 级

Temperature Considerations

Pressure ratings decrease as temperature increases. A Class 150 flange rated at 285 psi at ambient temperature may only be rated at 150 psi at 400°F (204°C).

Material Impact on Rating

• Carbon Steel (A105): Standard pressure-temperature ratings
• Stainless Steel (304/316): Similar ratings, better corrosion resistance
• Alloy Steel (F11/F22): Maintains strength at higher temperatures
• Duplex Steel: Higher strength allows thinner designs

Rating Selection Factors

1. Design Pressure: Maximum expected system pressure
2. Design Temperature: Maximum operating temperature
3. Safety Margin: Add 10-25% above normal operating pressure
4. Pressure Surges: Consider water hammer and transient conditions
5. Code Requirements: ASME B31.1, B31.3, or local regulations
6. Future Expansion: Allow for potential capacity increases

应避免的常见错误

• Using ambient temperature rating for elevated temperature service
• Ignoring pressure surges and transient conditions
• Mixing different pressure class flanges without proper reducers
• Not considering corrosion allowance for long-term service
• Overlooking vacuum conditions (external pressure)

Standards and Codes

• ASME B16.5: Pipe flanges and flanged fittings (NPS 1/2 to 24)
• ASME B16.47: Large diameter flanges (NPS 26 to 60)
• EN 1092-1: European steel flanges
• ASME B31.1: Power piping code
• ASME B31.3: Process piping code

Pressure Testing Requirements

Flanges are typically hydrostatically tested at 1.5 times their rated pressure to verify integrity before being put into service.

Proper flange pressure rating selection ensures safe, reliable, and code-compliant piping system operation throughout its design life.

WhatsApp： +86-18658777855
电子邮件： 1007788887@qq.com