Guida al dimensionamento e alla riparazione delle flange
Proper flange sizing and timely repair ensures safe pipeline operation.
Tabella di dimensionamento delle flange
- NPS 1/2 to NPS 24: Standard range
- DN15 to DN600: Metric sizes
- Classe 150-2500: Valori di pressione
- Custom sizes available
Metodi di riparazione delle flange
- Face resurfacing for minor damage
- Bore machining for worn surfaces
- Bolt hole repair and re-drilling
- Weld overlay for severe wear
How to Replace Flange
- Isolate and drain pipeline
- Remove old bolts and gasket
- Clean mating surfaces
- Install new flange and gasket
- Torque bolts to specification
- Pressure test before service
Ti potrebbe interessare anche
ASME B16.5 Flange Guide: 2025 Latest Edition, Scope, Ratings and Dimensions
A practical ASME B16.5 guide covering the 2025 latest edition, NPS 1/2 through NPS 24 scope, flange classes, dimensions, materials, markings, testing and differences from ASME B16.42.
Read 69 · Comments 0
-
2026-06-22
Weld Neck Flange Guide: Socket Weld vs Weld Neck Flange, Uses, Standards and Selection
A professional weld neck flange guide covering socket weld vs weld neck flange differences, advantages, standards, dimensions, materials, installation and quotation requirements.
Read 249 · Comments 0
-
2026-06-21
Casting vs Forging: How to Choose the Right Manufacturing Process for Industrial Flanges
Casting vs forging explained for industrial flange buyers: compare grain flow, mechanical properties, defect risks, cost, standards, inspection and application suitability before specifying a flange.
Leggi 172 - Commenti 0
-
2026-06-21